VIPA System 300V - Overview

Chapter 2 Assembly and installation guidelines Manual VIPA System 300V
2-2 HB130E - IM - Rev. 08/26
Overview
The single modules are directly installed on a profile rail and connected via
the backplane bus coupler. Before installing the modules you have to clip
the backplane bus coupler to the module from the backside.
The backplane bus coupler are included in the delivery of the peripheral
modules.
G
122
Order number A B C
VIPA 390-1AB60 160mm 140mm 10mm
VIPA 390-1AE80 482mm 466mm 8.3mm
VIPA 390-1AF30 530mm 500mm 15mm
VIPA 390-1AJ30 830mm 800mm 15mm
VIPA 390-9BC00* 2000mm
no Drillings
15mm
* Unit pack: 10 pieces
For the communication between the modules the System 300V uses a
backplane bus connector. The backplane bus connector are included in the
delivering of the peripheral modules and are clipped at the module from
behind before installing it to the profile rail.
General
Profile rail
Bus connector