VIPA System 300V - Page 55

Manual VIPA System 300V Chapter 3 Profibus DP
HB130E - IM - Rev. 08/26 3-29
Via the index A4h, the module configuration of DP slave can be monitored.
The assignment identification to module type can be found at the following
table:
Module type Identification Input byte Output byte
DI 8 9FC1h 1 -
DI 8 - Alarm 1FC1h 1 -
DI 16 9FC2h 2 -
DI 14 / 2C 08C0h 6 6
DI 32 9FC3h 4 -
DO 8 AFC8h - 1
DO 16 AFD0h - 2
DO 32 AFD8h - 4
DIO 8 BFC9h 1 1
DIO 16 BFD2h 2 2
AI2 15C3h 4 -
AI4 15C4h 8 -
AI4 - fast 11C4h 8 -
AI8 15C5h 16 -
AO2 25D8h - 4
AO4 25E0h - 8
AO8 25E8h - 16
AI2 / AO2 45DBh 4 4
AI4 / AO2 45DCh 8 4
To access the function modules with the Siemens SIMATIC Manager the
module address, which can be set by properties, is used as ID.
Using the following record set no. as Index you get access for reading (R)
res. writing (W) to the listed function module elements:
Index Access Description
R Diagnostic – record set 0
00h
W Write Module parameters
01h R Diagnostic – record set 1
device configuration
Data of the
function modules