Step-By-Step Patient Instructions
Viatom Oxyfit, analyzed by EnsoSleep PPG
SMARTPHONE REQUIRED: This sleep test requires you to have an
Apple or Android smart phone or tablet and connection to the internet.
INSTALL APP: Download the VirtuOx Sleep app from text message or email
link sent from VirtuOx, or go to the Apple App store or Google Play and
search for VirtuOx Sleep app. You should see the blue and grey virtuox logo.
You MUST allow bluetooth connections when prompted in the app.
NUMBER OF NIGHTS TO TEST:
CHARGE BATTERY: Make sure your finger sensor is sufficiently
charged (60% or more) before each night starting the test. A
charging cable is included, or any micro USB charging cable will
work. You may need to gently pull away the rubber seal covering
the charging port at the read of the device.
KEEP PHONE CHARGED AND CLOSE DURING NIGHT: You
will need to keep your phone charging all night and keep it within
3-6 feet of the fingertip sensor with no obstructions to maintain a
quality signal
MAKE SURE FINGER SENSOR IS POWERED OFF,
THEN OPEN VIRTUOX SLEEP APP ON YOUR PHONE
• Allow Bluetooth permissions. Accept terms. Click Continue.
• SCAN FOR DEVICES SCREEN – App will prompt you to power
on the sensor.
• POWER ON FINGER SENSOR: you should insert a finger into
the finger sensor or press power button on the side to power
it on.
• Tap SCAN. The app scans for and displays nearby finger sensors.
• Tap the desired device. Note the picture on screen may not
match your device exactly.
• Tap CONNECT - app shows that it is connecting to the sleep
device. (Continue to step 4 on back/next page)
DO NOT POWER ON FINGER SENSOR UNTIL PROMPTED IN APP
Keep the tip
of your
finger inside
the sensor
Charging
Port
under
rubber
seal
FOR ASSISTANCE CALL: 877-897-0063 Reference Reading ID:
To Next Page
Need help?
General
