• Exit from the learning function is automatic
after approx.
8 seconds of the last operation
(or its interruption) and is signaled by a long
flash of the LED.To enter the learning func-
tion again repeat from b).
• To learn a new command on a button that
has already been memorized it is necessary
to first clear the memory (4.2)
4.2) Cancellation procedures.
Cancellation procedures are used when wan-
ting to replace a learned command with
another learned command or restore a pre-
programmed command (See NOTE above).
4.2.A) Cancellation of only one button.
a) Press and release the « » button.
b) Enter the code «6 6 6 6».
c) Press the button to be cleared and watch
the LED that will confirm cancellation with
2 short flashes.
d) To cancel more commands repeat from a).
N.B.:Exit from cancellation mode is automatic
after approx.
8 seconds of the last operation.
4.2.B)Total cancellation (on all buttons of both
memory banks).
a) Press and release the « » button.
b) Enter the code «7 7 7 7» and watch the
LED that will confirm cancellation with two
short flashes.
5) “WHAT TO DO IF…”
- After the batteries have been inserted, the
LED will not flash when pressing the
« » button?
Check that the batteries have been inserted with
correct polarity.
- The automatic search was unsuccessful?
Repeat the operation and observe the
LED
After a while you will notice that the LED emits
5 short flashes indicating the end of a search
cycle.
Keep the search button pressed…if
your machine still does not respond and the LED
again emits 5 short flashes,abandon this proce-
dure and try inserting manually, one by
one, following the procedures in the pre-
vious chapters, all the codes listed in the
tables (Tab.A for TVs,Tab. C. for VCRs).
- You have some difficulties with the learning
function?
Try repositioning the two remote controls chan-
ging the distance and/or alignment.
- After a while the operation of the remote
control becomes erratic?
Make a note of the codes memorized (see also
para.
3
) and quickly change the batteries. If no
change,press (for example with the tip of a pen-
cil or non sharp object) the internal reset button.
Take notice: after pressing the RESET but-
ton it is necessary to enter again all the
required codes.
To Next Page
Loading...