23
Advanced Manual - Viscount
Prestige
5.6 SETTING THE ANTIPHONAL OUTPUTS
In the factory settings, the signals are distributed across the [ANTIPHONAL OUT] outputs as
follows:
- in Prestige 100 and 80
o outputs [9] and [10]: Choir and Swell voices. Orchestra voices
o outputs [11] and [12]: Great and Pedal Board voices and inputs [INPUT]
- in Prestige 70 and 60
o outputs [9] and [10]: Swell voices and Orchestra voices
o outputs [11] and [12]: Great and Pedal Board voices and inputs [INPUT]
- in Prestige 50 and 40
The function is not available.
For each pair of outputs, the signals follow the stereophonic channelling set for the internal
amplification system using the VOICES ADJUST Panning parameter (see also point 4.2) in the
VOICES menu.
This means that if a voice is set to play on the amplifier Left channel (Panning parameter Solo Left
setting), it will only be present on the left-hand Antiphonal output ([9] or [11]).
However, the ANTIPHONAL OUTPUTS SETTING function allows you to select other modes for
use of the Antiphonal outputs, so that they transmit the general signal, the signal with reverb effect
only, or both signals on two different pairs of outputs.
To display the setting video page, select the ANTIPH. OUT field (EXTERNAL ANTIPH. OUTPUTS
SETTING in the version with AFC):
ANTIPHONAL OUTPUTS SETTING:
ANTIPHONAL (9-10-11-12)
The meanings of the voices available are:
o ANTIPHONAL (9-10-11-12):
- in Prestige 100 and 80
In this mode the Choir and Swell and Orchestra voice signals are present on outputs [9] and
[10], while the Great, Pedal Board and input [INPUT] signals are present on outputs [11] and
[12].
- in Prestige 70 and 60
In this mode the Swell and Orchestra voice signals are present on outputs [9] and [10], while
the Great, Pedal Board and input [INPUT] signals are present on outputs [11] and [12].
To Next Page
Loading...
Need help?
General
