vision microsystems VM1000 - 1.9 EC100 INSTALLATION; EC100 Installation, Connection, and Wiring

SECTION
I
INSTALLATION
2I
1.9 EClOO INSTALLATION
1.9.1 EClOO INDICATOR NSTALI-ATION
Refer to the illustrations
for
dimensional
mounting information.
You
may first want to
perform
the wiring to the back
of the unit as the top
\--l
cover must be
removed.
1.9.2 EClOO TO
DPU
CONNECTION
Connect to
the DPU
flat display cable
at
any connector
location. Note
that
the
connectors
are keyed to
prevent
incorrect insertion
and also
that
the black
locking
arms
snap
over into
position.
1.9.3
ECl00
WIRING
USE 18
ouage
for the
qround
and
power
wires. The
audio signal
connects to the audio system of the
aircraft. Adjust
the desired
volume via the small slotted
screw located between
the two rear
connectors.
See
your
audio
panel
or radio
installation
manual for
the
proper
audio
input
connection locations.
NOTES: 1 .
Do not
install the
lO
Board
if using
the
EC100.
2. lnstall
jumpers
across WHT
& BLK locations
on J1 where
fuel level transducers
are not installed. Also install
jumpers
between
J3-1&3, J3-4&6,
J3-7&9,
J3-10&12.
3. Use
100o/o
shielded color
coded extension
cable
or splice
to connect the
probes
to the
EC100.
Connect
shield to
BLK wire at EC100 end.
5010002
REv F
VTT{IOOO
OWNERS MANUAL
EC100
TERM.
CABLE
COLOR
DESCRIPTION XDUCER
PART NO.
J1-1
WHT LEFT
FUEL LEVEL
WHT
3010009/1 0t12t13
J1-2
RED RED
1a
J1-3 BLK
BLK
J1-4
WHT RIGHT FUEL
LEVEL WHT
3010009/1
0t12t13
J 1-5 RED
RED
J1-6 BLK
BLK
J1-7 WHT CENTER FUEL LEVEL
WHT
3010009/1
0t12t13
J1-8
RED
RED
J 1-g BLK
II
BLK
Jl-1 0
(AN\')
ACFT AUDIO INPUT
N/A
J1-1
1 RED 2
AMP
BREAKER
N/A
J1-12
BLK GROUND
BUS
N/A