Visonic PowerMaster-30 - Initiating Alarms; Initiating Panic Alarm; Initiating Fire Alarm

D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide 15
B
A
C
D
E
F
A. Front unit
B. Back unit
C. PGM-5 Module
D. 2 Screws for fastening the PGM-5 Module
E. Flat cable
F. Wiring
Figure 3.7 – PGM-5 Module Mounting
2.2.8 Adding Wired Zones or PGM
Required tools: Cutter and slotted screwdriver - 3 mm blade.
PowerMaster-10 wiring is shown in Figures 3.8 – 3.11.
CABLES ROUTING GUIDE
1
A
B
2
C
A. Cables entry options
B. Back unit
C. Cable clips
To Route the Cable:
1. Remove the left or right side cables entry knockout(s) and enter the required cable(s)
2. Remove and use as cable clamp(s)