D-302415 RP-600 PG2 Installation Instructions 3
6
66
6.
. .
. COVER CLOSURE
COVER CLOSURECOVER CLOSURE
COVER CLOSURE
See Figure 5.
1
2
Figure 5:
Cover Closure
7
77
7.
. .
. NOTES AND WARNINGS
NOTES AND WARNINGSNOTES AND WARNINGS
NOTES AND WARNINGS
7.1 Product Limitations
Visonic Ltd. wireless systems are very reliable and are tested to high
standards. However, due to their low transmitting power and limited
range (required by FCC and other regulatory authorities), there are
some limitations to be considered:
A. Receivers may be blocked by radio signals occurring on or near
their operating frequencies, regardless of the code selected.
B. Wireless equipment should be tested regularly to determine whether
there are sources of interference and to protect against faults.
8
88
8
COMPLIANCE WITH STANDARDS
COMPLIANCE WITH STANDARDSCOMPLIANCE WITH STANDARDS
COMPLIANCE WITH STANDARDS
Compliance with Standards
1 Grade 2, Class II, EN 50130
The RP-600 is compatible with the RTTE requirements - Directive 1999/5/EC of the European Parliament and of the
Council of 9 March 1999 and EN50131-1 Grade 2 Class II.
Certified by Norwegian accredited certification body Applica Test & Certification AS in accordance with
EN 50131-3, EN 50131-6, EN 50131-5-3, EN 50130-4 and EN 50130-5. Environmental Class II, Security
Grade 2.
Applica T&C has certified only the 868 MHz variant of this product.
USA: (FCC) CFR47 Part 15
Canada: RSS 210
UK: This product is suitable for use in systems installed to conform to PD6662:2010 at Grade 2 and
environmental class 2. DD243 and BS8243
The Power G peripheral devices have two- way communication functionality, providing additional benefits as
described in the technical brochure. This functionality has not been tested to comply with the respective
technical requirements and should therefore be considered outside the scope of the product’s certification.
EN 50131-1 Security Grade
According to EN 50131-1:2006 and A1:2009, this equipment can be applied in installed systems up to and
including Security Grade 2.
EN 50131-1 Environmental
Class
Class II
FCC Compliance Statement
The digital circuitry of this device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio and television reception. However, there is no guarantee that interference will not occur in a particular installation. If this
device does cause such interference, which can be verified by turning the device off and on, the user is encouraged to eliminate the interference
by one or more of the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from the one which supplies power to the receiver.
– Consult the dealer or an experienced radio/TV technician.
WARNING! To comply with FCC and IC RF exposure compliance requirements, the repeater should be located in a distance of at least 20 cm
from all persons during normal operation. The antennas used for this product must not be co-located or operated in conjunction with any other
antenna or transmitter.
Interference Prevention
This device complies with FCC Rules Part 15 and with Industry Canada licence-exempt RSS standard(s). Operation is subject to two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference that may be received or that
may cause undesired operation.
WARNING! Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
W.E.E.E. Product Recycling Declaration
For information regarding the recycling of this product you must contact the company from which you orignially purchased it. If you are discarding this product and not
returning it for repair then you must ensure that it is returned as identified by your supplier. This product is not to be thrown away with everyday waste.
Directive 2002/96/EC Waste Electrical and Electronic Equipment.
To Next Page
Loading...