Vitalograph copd-6 BT - 3.5. Downloading saved results

3.5. Downloading saved results
The test session may be transmitted to Vitalograph Reports on your
PC to be stored as a PDF le and viewed or printed.
Vitalograph Reports must be installed and running on the PC before
data is transmitted. The software is running if the Vitalograph ’V’
icon shows in the PC System Tray. If not, refer to help button of the
software for more information. The Bluetooth Adaptor should be
plugged in to the host PC to allow communication. Drivers should
automatically install.
1. Run Vitalograph Reports.
2. If ‘No devices have been detected’ message appears, click
‘Continue’.
a. Turn device on, .
b. In Vitalograph Reports ensure ‘Vitalograph COPD-6’ is
selected via the Device Selection Button
3. To print test results from the COPD-6 BT:
When the device is ready for age entry, press button
for 3 seconds for the last saved session. Use the or
buttons to scroll to the Report icon ( ).Press to
print. Click the “Start” button on the main screen of
Vitalograph Reports.
OR
After completing the test session, press the or
buttons until the Report icon ( ) displays Press
to print. Click the “Start” button on the main screen of
Vitalograph Reports.
4. In Vitalograph Reports enter the Subject Demographic
details and Comments. Select ‘Continue’.
5. Select a location for the test report on your PC. A PDF of
the test results opens and is also stored to the chosen
location on the PC.