3. The appliance must not be installed in a room without a window or other controllable opening. If is installed
in a room without a door which opens directly to the outside, a permanent opening is required. The air
circulation should be 2 m3/h per kW of burners.
4. The gas connection should be performed from the right or left. For this reason, change the hose nozzle, plug
and the seals.
5. Please use flexible hose for gas connection.
6. If you make a connection with a flexible metal hose, locate a seal between the main gas pipes.
7. The inner diameter of the flexible hose, which the butane hose nozzle is connected, should be 6mm for the
house-type gas tubes. The inner diameter of the flexible hose, which the natural hose nozzle is connected,
should be 15mm.The hose should tightly be fitted to the hose nozzle by squeezing with a clamp.
8. The hose should be replaced before its last expiry date.
9. Caution! Make the oven connection to the gas inlet valve, the hose length must be short and be sure that
there is no leakage. The hose used should not be longer than 125 cm for safety.
10. RE-INSPECT THE GAS CONNECTION.
11. When placing your oven to its location, ensure that it is at the counter level. Bring it to the counter level by
adjusting the feet if necessary.
DO NOT MAKE GAS HOSE and ELECTRICAL CABLE OF YOUR OVEN GO THROUGH THE HEATED
AREAS, ESPECIALLY THROUGH THE REAR SIDE OF THE OVEN. DO NOT MOVE GAS
CONNECTED OVEN. SINCE THE FORCING SHALL LOOSEN THE HOSE, GAS LEAKAGE MAY
OCCUR.
To Next Page
Loading...