108
• Connect the transmitter to the target line using a direct connection only.
• If several lines are commonly bonded the Signal Direction will carry through to the other lines. This
is useful for locating multiple line installations.
• When performing a reset, take care to ensure that you have not strayed from the target line.
• There will be a point at which it is not possible to reset and continue.
• However beware that if a non target line is commonly bonded to the target line that line will also
appear as being “in Sync” with the target line.
Signal Direction (SD) - Transmitter Setup
To Next Page
Loading...
Need help?
General
