170
Accessories - Clamp Extension Rod
• The extension rod is fitted with a 10mm screw
thread. This male thread will screw into the handle of
the signal clamp and will enable the clamp to be
attached too hard to reach cables such as in
manholes or overhead cables.
• The extension rod is also fitted with a female thread
in the handle which enables the rods to be fitted
together to further extend the range. To access this
thread the yellow handgrip needs to be slid of the
end of the rod.
• To operate the clamp jaws when attached to the rod,
gently pull on the clamp cord which will open the
jaws. Release to cable to close them.
To Next Page
Loading...
Need help?
General
