38
Loc3 Series Transmitters - Charging the Battery
Follow instructions detailed in the “General Safety & Care” Information section of this document.
Only use the battery charger supplied. Using a unapproved charger may damage the battery pack
and could cause overheating.
To charge, the rechargeable batteries pack must be connected to the transmitter. Connect the
mains charger to the charging socket on the side of the transmitter and connect the charger to a
suitable mains socket. Or if needed rechargeable tray can be charged independently.
The LED on the charger will show a red light indicating that the charge cycle is in progress. When
the batteries are fully charged the LED will change to green.
1 - Output (Connection
2 - Output Protection (Fuse)
3 - Loudspeaker
4 - Battery Charging Socket & DC Input
To Next Page
Loading...
Need help?
General
