Vivax Metrotech vLoc3-MLA Training

44
Using a Signal Clamp
• Use when you cannot direct connect to a utility, or
insulated sheath or for cable identification.
• Place the clamp around the utility.
• Connect below the grounding point (to ensure the
signal has a signal path between near and far ground
points).
• For best results the utility line must be grounded at
each end.
* Clamps are designed for specific frequencies only, typically 8 kHz – 83 kHz
Applying The Transmitter Signal - Signal Clamp

Vivax Metrotech vLoc3-MLA Specifications

General

Brand	Vivax Metrotech
Model	vLoc3-MLA
Category	Receiver
Language	English