71
vLoc3-Pro Receiver Display - Warnings
Warnings can be displayed in real time across the display
This a very unusual situation and is usually caused by operating very close to a power transformer or
placing the unit very close to a transmitter in the Induction mode. Moving slightly away from the
interfering signal will cure the problem. Signal overload will not cause damage to the instrument.
This indicates that the locator has detected a cable that is possibly less than 15cm deep. Proceed
with caution.
This indicates that the operator is swinging the locator excessively and could result in misleading
information. When sweeping the locator across the direction of the line, try to keep it vertical. This will
improve accuracy.
This indicates that the signal is mainly radiating from above. This is usually caused by the signal travelling
along overhead cables.