Need help?Do you have a question about the Vivax Metrotech vLocML2 and is the answer not in the manual?
General| Brand | Vivax Metrotech |
|---|---|
| Model | vLocML2 |
| Category | Camera Accessories |
| Language | English |
Outlines essential safety rules and procedures for operating equipment on site.
Covers crucial safety precautions related to the equipment itself.
Addresses battery types, handling, disposal, and environmental impact.
Advice on interpreting locator signals and potential distortions.
Step-by-step instructions for charging the receiver's batteries.
Description of the various locating modes available on the receiver.
Explains the Peak Response Mode for precise signal identification.
Methods for adjusting the receiver's sensitivity.
How to select and manage operating frequencies for locating.
Using the 'i' button to obtain depth and current measurements.
Overview of the operating modes for the vLocML2 receiver.
Using the vLocML2 specifically for detecting passive markers.
Procedure for estimating marker depth in dedicated mode.
Using the vLocML2 for tracing cables and detecting markers simultaneously.
Steps to transfer logged data from the locator to a computer.
Transferring data using the MyLocator2 software.
Introduction to the MyLocator2 configuration and data transfer software.
How to upload and save data files from the locator.
Procedure for updating the locator's software via computer.
Information on transmitter battery types, removal, and replacement.
Instructions for replacing alkaline batteries in the transmitter.
Guidelines for charging and disposing of transmitter batteries.
Overview of the transmitter's automatic transmitting modes.
Detailed explanation of using the transmitter in Induction Mode.
Detailed explanation of using the transmitter in Direct Connection Mode.
Using the transmitter in Clamp Mode with important safety warnings.
Information on available frequencies and power output settings for the transmitter.
Information on transmitter battery types, removal, and replacement.
Instructions for replacing alkaline batteries in the transmitter.
Guidelines for charging and disposing of transmitter batteries.
Using the transmitter in Induction Mode.
Using the transmitter in Direct Connection Mode.
Using the transmitter in Clamp Mode.
How to locate pipes and cables using the receiver.
Measuring depth and current of buried lines.
How to locate sondes using the receiver.
Explanation of passive and active location methods.
How to perform active locating using a transmitter.
Methods for applying the transmitter signal to a target line.
Methods for accurately pinpointing a buried line.
Dealing with distorted signal fields and inaccurate readings.
Detailed methods for measuring depth and current.
Verifying the correct line using signal direction.
Using the A-frame accessory for detecting ground faults.
Using the remote stethoscope antenna to identify cables.
To Next Page
