ENG VIVAX
9
HEATING POWER SELECTION
Press the “FUNCTION ” button repeadetely, the heater will be switched as per the
circular order of "High gear - Low gear - ECO energy saving gear - CO" heating
power.
TEMPERATURE SETTINGS
When the Fan Heater in ECO mode , the temperature can be set by pressing "+" or
"-" keys, with the setting range of 5-35°C.
When the setting temperature is reached, the fan heater will stop the operation; when
the temperature is lower than the set temperature, the machine will restart the heating.
TIMER Settings
Turn Off Timer - Set the heater's automatic shutdown time.
Adjust timeWhen the heater is in Active working mode, press the TIMER key to enter
the Timer function (within 0-24 hours).
Press the "+" key to increase the Turn Off Time.
Press the "-" key to decrease the Turn Off time.
After the Shutdown time is set, the Timer can be canceled through long-press of the
TIMER key.
Turn On Timer-Set the heater's automatic switch-on time.
When the electric heater is in the Standby mode, press the TIMER key to enter the
Timer Start mode (within 0-24 hours).
Press the "+" key to increase the Start time.
Press the "-" key to decrease the Start time .
Long-Press TIMER key to cancel the Timer. After the Startup time is set, the Timer
can be canceled through long-press of the TIMER key.
LED DISPLAY On/Off
When the heater is turned on and there is no operation in 60 seconds, the LED display
will turn off. When LED display is off, press any button to wake up the display.
When the heater is turned on, press and hold on "+" and "-" at the same time for 3
seconds to turn on the LED display permanently. Then press and hold on "+" and "-"
at the same time for 3 seconds to turn off the LED display.
SWING FUNCTION
When the machine is under operating mode, press "Swing " button to start swing
function.
Press button " Swing " again to cancel Swing function.
FORCED SHUTDOWN
After the heater is powered On and started, it will be automatically shut down forcibly
in case of no valid operation after 12h continuous operation.
SHORT-CIRCUIT AND OPEN-CIRCUIT PROTECTION FUNCTION
In case the temperature sensor has short circuit or open circuit, regardless of the
mode, the digital screen will display "E2" or "E1" and be illuminated, at this time, the
operation of any button is invalid, and the buzzer will be ringing for 10 times.
To Next Page
