VIVAX ENG
8
2. Setting of oscillate horizontal wind direction
Pressing the turning button and the head starts to rotate, then pull it out and fan will stop
rotating.
3. Setting of wind speed
Press SPEED ON/OFF button. You can choose 3 speeds of air
circulation. Each time the button is pressed, you adjust the air
circulation speed from Min (L), Middle (M) to High (H). The LEDs will
light up with a certain mark, depending on the selection.
4. Setting the Timer
In case that you would like to use Timer (switch off Fan after adjusted
time) press TIMER button. The LEDs will light up with a certain mark,
depending on the Timer selection.
Each TIMER button adjust timer time in the following circle:
LED Light 1 2 1 + 2 4 1+4 2+4 1+2+4
No LED
lights
Hour(s) 1h 2h 3h 4h 5h 6h 7h
Remote
You can use remote control to control FAN functions like on unit control
panel.
SOLUTION TO SIMPLE FAILURE
When starting the fan, the fan blade doesn’t work:
Please check whether the power plug has really inserted into the socket
or the cover has distorted, which has touched the fan blade.
When starting the fan, loud noise appears:
Please check the unit as following:
1. Fan blade has been tight installed into the output shaft of motor.
2. Groove on back of cover has matched the inserting groove on the output shaft.
3. There are tiny defective edge ring existing around the fan blade.
4. The cover has distorted, which has touched the fan blade.
INSTRUCTIONS FOR CLEANING
Should you need to clean the fan:
Unplug the fan from the power outlet.
Wipe it down with a damp cloth and a small amount of non-abrasive cleaning
agent.
Never get the fan wet.
Do not use the appliance it if it is wet.
Clean the air inlet and outlet regularly. You may use a vacuum cleaner for this.
To Next Page
Loading...
Need help?
General
