VIVAX ENG
4
Do not allow the air inlet to become blocked or even
partially blocked. This may cause the fan to overheat. If it
does overheat, the safety cut-out will cause the fan to
switch off and remain inoperable until the unit has
sufficiently cooled down. In this event, switch off the
appliance, unplug it and let it cool down. Remove any
blockage to the air inlet or outlet before resuming use. If
the fan should cut out again, even when there is no
blockage, contact the approved service center for
examination and repair.
Do not cover the fan or place anything over it.
Do not place anything through the grills or into the fan.
Do not use the fan if it is not properly and completely
assembled.
Do not use the fan without the mesh guards, as this could
lead to injury. Ensure that the fan is switched off from the
supply mains before removing the guard.
Do not use the fan within 1 meter of any other electrical or
electronic appliance (e.g.TV,computer,etc.) as it may
cause interference.
The installation of a residual current-operated protective
device with a nominal trip current of 30mAh offers
additional protection. Contact your electrician.
Caution:
1. The appliance is not intended to be operated by means of
an external timer or separate remote-control system.
2. Make sure your hands are dry when plugging in and
unplugging appliance.
3. Ensure all the parts are correctly mounted before
switching on the appliance.
4. Do not immerse the appliance in water or any other liquid.
5. Always remove the plug after use.
To Next Page
Loading...
Need help?
General
