EasyManuals Logo

Vivax TTL-112 User Manual

Vivax TTL-112
Go to English
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
ENG VIVAX
15
For
the first time you install your refrigerator, set the thermostat knob at Mid(middle
position).
Give your freezer time to cool down completely before adding food. It is the best to w
ait
24 hours befo
re adding food. The thermostat knob controls the temperature.
W
hen the Thermostat knob is turned up to the end position, below the "Min"
position, the Refrigerator will stop cooling
.
W
ARNING: In the lowest Thermostat position, although the fridge is not cooling,
it does not mean that the device is disconnected from the power supply. For
cleaning and maintenance, to disconnect the power supply pull the power plug
out of the socket!
Noise Inside the Unit!
You may notice that your unit makes some unusual noises. Most of these are perfectly
normal, but you should be aware of them!
These noises are caused by the circulation of the refrigerant liquid in the cooling system. It
has become more pronounced since the introduction of CFC free gases. This is not a fault
and will not affect the performance of your unit. This is the compressor motor working, as it
pumps the refrigerant around the system.
Change the Light Bulb (if exists)
The LED lamp must be replaced by authorized service. Please contact authorized service
or manufacturer.
Maintenance of Refrigerator
Cleaning
Please unplug the Freezer for defrost and cleaning
Dusts behind the freezer and on the ground shall be timely cleaned
to improve the cooling effect and energy saving.
The interior of the freezer should be cleaned regularly to avoid
odor. Soft towels or sponge dipped in water and non-corrosive
neutral detergents are suggested for cleaning. The freezer of shall
be finally cleaned with clean water and dry cloth. Open the door for
natural drying before the power is turned on.
Remove all the shelves.
Wipe the inside of the unit with a weak solution of bicarbonate
soda
and then rinse with warm water using a wrung-out
sponge or cloth. Wipe completely dry before replacing the shelv
es and salad bin.
Use a damp cloth to clean the exterior, and then wipe with a standard furniture polish.
Make sure that the door is closed to avoid the polish getting on the magnetic door s
eal
or inside the unit.
The grille of the condenser at the back of the unit and the adjacent components
can be vacuumed using a soft brush attachment.
91 / 118

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vivax TTL-112 and is the answer not in the manual?

Vivax TTL-112 Specifications

General IconGeneral
BrandVivax
ModelTTL-112
CategoryFreezer
LanguageEnglish

Related product manuals