VIVOTEK
User's Manual - 65
Please follow the steps below to set up a prole:
1. Select the
Prole mode
tab.
2. Select the applicable mode: Night mode or
Schedule mode. Please manually enter a range of
time if you choose the Schedule mode.
3. Congure Exposure control settings in the folowing
columns. Please refer to previous dicussions for
detailed information.
4. Click
Save
to enable the setting and click
Close
to
exit the page.
You can click
Restore
to recall the original settings without incorporating the changes. When
completed with the settings on this page, click
Save
to enable the settings.
If you want to congure another sensor setting for day/night/schedule mode, please click
Prole
to
open the Prole of exposure settings page as shown below.
Activated period:
Select the mode this profile to apply to: Day mode, Night mode, or Schedule
mode. Please manually enter a range of time if you choose Schedule mode. Then check
Save
to
take effect.
To Next Page
Loading...
Need help?
General
