Vivotek IB9391-EHT - Page 187

VIVOTEK
User's Manual - 187
*Only valid when "ratecontrolmode"=
cbr

s<0~(m-1)>_h
264_prioritypoli
cy
framerate,imagequality 4/4 Set prioritypolicy
*Only valid when "ratecontrolmode"=
cbr

s<0~(m-1)>_h
264_maxframe
1~"capability_videoin_c<0~(n-1)>_h
264_maxframerate"
1/4 The maximum frame rates of a H264
stream at different
resolutions("capability_videoin_c<0~
(n-1)>_resolution") are recorded in
"capability_videoin_c<0~(n-1)>_h26
4_maxframerate"
s<0~(m-1)>_h
264_profile
0~2 1/4 Indicate H264 profiles
0: baseline
1: main profile
2: high profile
s<0~(m-1)>_h
264_smartq_en
able
<boolean> 4/4 Enable "Smart Q" function.
* Only available when
"capability_videoin_c<0~(n-1)>_sma
rtq_support" is 1.
* We support this parameter when the
version number (httpversion) is equal
or greater than 0309a.
s<0~(m-1)>_h
265_dintraperio
d_enable
<boolean> 4/4 Enable "Dynamic intra frame period".
* Only available when
"capability_videoin_c<0~(n-1)>_dint
raperiod_support" is 1 and h265 is
listed in "capability_videoin_codec".
* We support this parameter when the
version number (httpversion) is equal
or greater than 0301c.
s<0~(m-1)>_h
265_intraperiod
250, 500, 1000, 2000, 3000, 4000 4/4 The time interval between two
I-frames (Intra coded picture).
The unit is millisecond (ms).
* Only available when h265 is listed in
"capability_videoin_codec".
s<0~(m-1)>_h
265_ratecontrol
cbr, vbr 4/4 cbr: Constant bit rate mode.
vbr: Fixed quality mode, all frames are