Vivotek IB9391-EHT - Page 204

VIVOTEK
204 - User's Manual
7.10 IR cut control
Group: ircutcontrol (capability.nvideoinprofile> 0 and capability_daynight_c<0~(n-1)>_support > 0)
n denotes the value of "capability_nvideoin"
NAME VALUE SECURITY
(get/set)
DESCRIPTION
mode auto,
day,
night,
di,
schedule
<product
dependent>
6/6 Set IR cut control mode
sir
<product dependent>
<boolean> 6/6 Enable/disable Smart IR
* Only available when
"capability_daynight_c<0~"capability_nvideoi
n"-1>_smartir" is 1
daymodebegintime 00:00~23:59 6/6 Day mode begin time
daymodeendtime 00:00~23:59 6/6 Day mod end time
disableirled <boolean> 6/6 Enable/disable built-in IR led
(capability_daynight_c<0~"capability_nvideoi
n"-1>_buildinir > 0)
enableextled <boolean> 1/6 Enable/disable external IR led
(capability_daynight_c<0~"capability_nvideoi
n"-1>_externalir > 0)
extledmode do, irring
* Available values
are listed in
"capability_daynight
_c<0~(n-1)>_extle
d_interface"
6/6 Turn on an external IR led which is mounted do
(digital output) device or is a IR ring device.
* Only available when
"capability_daynight_c<0~"capability_nvideoi
n"-1>_externalir" is 1.
* Only valid when "ircutcontrol_enableextled"
is 1.
bwmode <boolean> 6/6 Switch to B/W in night mode if enabled.
* Only available when
"capability_daynight_c<0~(n-1)>_
blackwhitemode" is 1.
sensitivity low, normal, high
(if
capability_daynight
6/6 Sensitivity of day/night control.
There are two value format: