Vivotek IB9391-EHT - Page 366

VIVOTEK
366 - User's Manual
8.36 Peripheral control (capability_peripheral_c<0~(n-1)>_
devicecontrol > 0)
Note: This request requires Administrator privileges.
Method: GET/POST
Syntax: (for control API)
http://<servername>/cgi-bin/admin/peripheral.cgi?channel=<value>&operation=set
[&washer_mode=<value>] – Set washer mode
[&washer_status=<value>] – Set washer status
[&washer_dwelltime=<value>] – Set washer clean time
[&heater_status=<value>] – Set heater status
Example:
http://myserver/cgi-bin/admin/peripheral.cgi?channel=0&operation=set&washer_mode=wiper&
washer_status=on
Response:
HTTP/1.0 200 OK\r\n
Cache-control: no-cache\r\n
Pragma: no-cache\r\n
\r\n
"washer_mode : OK\r\n"
"washer_status : FAIL\r\n"
PARAMETER VALUE DESCRIPTION
channel 0~"capability_nvideoin"-1 Channel of the video source.
washer_mode wiper Apply the wiper to the mode of washer control
system.
*Only available when
capability_peripheral_c<0~(n-1)>_washer_supp
ort=1
washer Apply the washer to the mode of washer control
system.
*Only available when
capability_peripheral_c<0~(n-1)>_washer_supp
ort=1
washer_status on Enable the functionality of washer control system.