1
5
E400i-B2
To install the stand:
1. Align the base with the neck piece and tighten three (3)
of the included Phillips screws with a Phillips screwdriver as
shown.
2. Align the stand with the TV and slide it into place as shown.
3. Tighten the remaining four (4) Phillips screws into the back
of the TV as shown.
4. When you are finished, place the TV on a stable, level
surface.
E320i-B2
To install the stand:
1. Align the stand with the bottom of the TV and slide it into
place as shown.
2. Using a Phillips screwdriver, tighten the pre-installed screw in
the center of the base to secure the stand to the TV.
3. When you are finished, place the TV on a stable, level
surface.
To Next Page
Loading...
Need help?
General
