VM Motori D704TE2 User Manual

- 50 -
C145301000.fm
English
Maintenance information
GB
D700/750 E2-E3
Follow the procedure below.
1- Start the engine and run it at
minimum speed for a few minutes.
The cooling circuit reaches the op-
erating pressure.
2-Turn off the engine and remove
the ignition key.
3-Let the engine cool down ade-
quately to avoid being burnt.
4-Prepare a container of appro-
priate capacity.
As for the liquid quantity, see
"Technical data".
5-Unscrew the load plug (P).
Warning - Caution
Open the plug gently to drain the
pressure.
6-Open the cock (S).
Important
– In the absence of a coolant discharge
tap, check for the presence of a dis-
charge plug or loosen one of the cooling
circuit clamps in the lower part of the
cooler.
– For further information, please con-
sult the documentation provided by the
manufacturer of the vehicle/device in
which the engine is installed.
7-Let the liquid flow into the container.
8-Close the cock (S).
9-Pour in the new liquid.
Important
– The fluid level must be up to the base
of the neck into which the radiator plug is
screwed.
– If there is a coolant expansion tank,
consult the documentation provided by
the manufacturer of the vehicle/device in
which the engine is installed.
– As for the liquid quantity and type, see
"Technical data".
10-Screw again the plug (P).
COOLANT REPLACEMENT
IDM-45300901500.tif
Filler cap (P)
Tap (S)

VM Motori D704TE2 Specifications

General

Brand	VM Motori
Model	D704TE2
Category	Engine
Language	English