To Next PageTo Next Page
Need help?Do you have a question about the Vmar DEHAVILLAND BEAVER 120 ARF and is the answer not in the manual?
Instructions for preparing servo cavities, including wiring harness tubes and servo rails.
Guides on installing servos and connecting them to the wiring harness, specifying torque requirements.
Instructions for preparing aileron servo cavities, including wiring harness tubes and servo rails.
Guides on installing servos and connecting them to the wiring harness, specifying torque requirements.
Details the process of attaching control horns to the ailerons using bolts, washers, and nuts.
Guides on connecting control rods between servo arms and control horns for the ailerons.
Details the process of attaching control horns to the flaps using bolts, washers, and nuts.
Guides on connecting control rods between servo arms and control horns for the flaps.
Instructions for aligning engine mounts to the firewall based on thrust lines.
Details drilling and securing the T-beam mounts to the firewall, including plywood spacers.
Details installing firewall mounting bolts, washers, and nuts to secure the power module.
Explains how to adjust and set vertical and horizontal engine thrust angles for optimal performance.
Guides on preparing and gluing the wooden servo tray inside the fuselage.
Details connecting the throttle servo control rod to the engine throttle arm for smooth operation.
Instructions for preparing the universal servo trays and attaching slider plates.
Guides on installing servos, connecting control rods, and using Y-harnesses for dual servos.
Guides on fitting and preparing the horizontal stabilizer for gluing to the fuselage.
Explains how to check and adjust the Center of Gravity (CG) for proper balance.
Guides on setting the correct throw limits for elevators, rudder, ailerons, and flaps.
Emphasizes thoroughly checking all connections, surfaces, and components before the first flight.
General
