Vogelzang International VG5770 User Manual (English)

Other manuals for Vogelzang International VG5770

Questions and Answers:

K
Kimberly GregoryAug 25, 2025
What to do if my Vogelzang International Wood stove display is flashing 'E1'?
- C
  Crystal BrewerAug 26, 2025
  If your Vogelzang International Wood stove display is flashing 'E1', it could be due to the convection blower overheating. Clean any dust off of the windings and fan blade of the convection blower. If oiling the blower does not help, the blower may be bad. If operating the heater on the highest heat setting, the room temperature could increase enough and lead to potential overheating situations, so try operating at a lower heat setting. Check for signs of fuel other than wood pellets, as no other types of fuel have been approved for this pellet stove, and stop using them immediately if found. Check to see if a surge protector is being used on the stove. If not, recommend one. If the other items check out OK, replace the high limit switch.
F
Francis RamosAug 27, 2025
Why does my Vogelzang International Wood stove smell like smoke?
- D
  dawn88Aug 27, 2025
  If you notice a smoke smell coming from your Vogelzang International Wood stove, inspect all vent pipe connections to ensure they are sealed with RTV silicone that has a temperature rating on 500 degree F or higher, and seal joints with UL-181-AP foil tape. Also, make sure the square to round adapter piece on the combustion blower has been properly sealed with the same RTV. Inspect both gaskets on the combustion blower to make sure they are in good shape.
O
omcdonaldAug 29, 2025
What does it mean when my Vogelzang International VG5770 display is flashing 'E5'?
- K
  Kimberly MitchellAug 29, 2025
  If your Vogelzang International Wood stove automatically flashes 'E5' when turned on, check to see if the sensor is unplugged. If the sensor is not unplugged then the sensor is damaged or has a short. If the sensor is damaged or has a short it will need to be replaced.
L
lisa84Aug 30, 2025
Why does the high limit switch keep tripping on my Vogelzang International Stove?
- C
  Catherine LongAug 30, 2025
  If your Vogelzang International Stove's high limit switch keeps tripping, it could be due to several reasons: * The convection blower may be overheating. Try cleaning any dust off the windings and fan blades. If oiling doesn't help, the blower might be defective. * Operating the stove on the highest heat setting for too long can cause overheating. Try using a lower heat setting. * Using fuel other than wood pellets can also cause this issue. Make sure you are only using approved wood pellets. * A power surge could be the cause. Ensure you are using a surge protector. * The high limit switch itself may be malfunctioning. If other solutions don't work, consider replacing the switch.
F
Felicia NicholsSep 1, 2025
How to fix flashing 'E1' on Vogelzang International Stove?
- D
  Debbie DanielSep 1, 2025
  If the display on your Vogelzang International Stove is flashing “E1”, here are some potential causes and solutions: * The convection blower might be overheating. Clean any dust off the windings and fan blade. Oiling the blower might help; if not, it may be defective. * Operating the stove on the highest setting for too long can cause overheating. Try operating at a lower heat setting. * Using fuel other than wood pellets can cause this issue. Ensure you are only using approved wood pellets. * A power surge could be the cause. Ensure you are using a surge protector. * The high limit switch may be malfunctioning. If other solutions don't work, consider replacing the switch.
A
angela98Sep 5, 2025
Why does the convection blower shut off and come back on in my Vogelzang International Stove?
- F
  Frank JonesSep 5, 2025
  If the convection blower in your Vogelzang International Stove shuts off and comes back on, it could be due to: * The convection blower overheating and tripping the internal temperature shutoff. Clean any dust off of the windings and fan blades. If cleaning the blower does not help, the blower may be bad. * A circuit board malfunction. Test the current going to the convection blower. If there is power being sent to the blower when it is shut off, then the control board is fine.
C
Christy RuizSep 7, 2025
Why is there a smoke smell coming back into my home from my Vogelzang International Stove?
- T
  Theresa SilvaSep 7, 2025
  To address smoke smell coming back into the home from your Vogelzang International Stove, check the following: * Inspect all vent pipe connections for leaks and ensure they are sealed with RTV silicone rated for 500°F or higher. * Inspect both gaskets on the combustion blower to make sure they are in good shape.
L
Lance GonzalezSep 9, 2025
What to do if Vogelzang International Stove display is flashing 'E5'?
- K
  Kathryn MorenoSep 9, 2025
  If the display on your Vogelzang International Stove is flashing “E5”, the T-stat sensor may have come unplugged from the control board. Check to see if the sensor is unplugged. If the sensor is not unplugged, then the sensor is damaged or has a short and will need to be replaced.
J
Juan McleanSep 12, 2025
Why is my Vogelzang International Wood stove display flashing “E1”?
- R
  Rachel WilliamsSep 12, 2025
  If the Vogelzang International Wood stove display is flashing “E1”, several issues could be the cause. First, the convection blower may be overheating; clean any dust off the windings and fan blade, and consider oiling the blower. If the issue persists, the blower may be faulty. The stove may be operating on the highest setting for too long, leading to overheating; try a lower heat setting. Ensure only wood pellets are used as fuel; using other fuels is not approved and should be stopped immediately. A power surge could also be the problem; check if a surge protector is in use. Finally, the high limit switch might be malfunctioning and may need replacement.