Need help?Do you have a question about the VolantexRC Hurricane 791-2 and is the answer not in the manual?
General| Brand | VolantexRC |
|---|---|
| Model | Hurricane 791-2 |
| Type | RC Boat |
| Hull Material | ABS Plastic |
| Transmitter | 2.4GHz 2-CH |
| Propeller | Plastic |
| Recommended Environment | Lakes, Ponds, Calm Waters |
Defines terms like NOTICE and WARNING for potential harm and outlines usage precautions.
States product is not for children under 14 and is not a toy.
Lists essential safety measures for operating the boat, including distance, environment, and handling.
Instructions for setting up the display base by inserting tubes into sockets.
Guide to setting up the keel, water-proof rubber piece, and ballast using screws and an allen key.
Steps to insert the rudder, connect it to the arm, and secure it, along with attaching the waterproof cover.
Connecting mast components, cranes, and sails, including hanging the main sail with luff rings.
Procedure for hanging the main sail on the backstay crane using the pre-rigged cord.
Guide for inserting the fully installed mast into the hull of the Hurricane boat.
Instructions for taking cord 'A' from the storage board and attaching it to the forestay.
Instructions for taking cord 'B' from the storage board and attaching it to the backstay.
Detailed steps for attaching rigging cords 'L1' and 'R1' to the backstay crane and shrouds cross.
Steps for attaching cords 'L2' and 'R2' to the forestay crane and shrouds cross on both sides.
Instructions for attaching cords 'L3' and 'R3' to the shrouds cross on port and starboard sides.
How to hook the clevis on the jib sail to the forestay crane.
How to hook the clevis on the deck to the silicone ring of the jib sail.
Unleashing jib boom cord and routing it through deck eyelets to the hull clevis.
Unleashing main boom cord and routing it through deck eyelets to the hull clevis.
Guide to adjusting silicone ring positions on main and jib booms.
Detailed instructions for adjusting silicone rings (SR1-SR5) for sail tension and angle.
Adjusting SR6 for jib boom expand distance to mast at lowest sail stick position.
Adjusting SR7 for distance between jib boom and mast, aiming for 8-12mm clearance.
Rotating counterweight to adjust jib boom swing CG position on SR7.
Adjusting mast bend angle using a bowsie, ensuring a straight center line.
Using a bowsie to tighten or loosen the jib sail.
Using a bowsie to tighten or loosen the jib boom.
Using a bowsie to adjust the distance between the jib boom and the deck.
Using a bowsie to tighten or loosen the main sail.
Adjusting mast bend angle with a bowsie, ensuring straightness.
Loosening screw to move boomvang for main boom height adjustment.
Step-by-step guide to bind the transmitter and receiver for communication.
Explains how the sail stick controls main and jib sail expand angles based on wind.
Describes how the rudder stick controls the direction of the boat's rudder.
Explains sail trim and rudder trim for adjusting neutral sail/rudder positions.
Sails expand at 45° angle; rudder in center.
Expand sails more angle, rudder to the left.
Expand sails max angle, rudder in center.
Expand sails max angle, rudder in center.
Pull back sails, rudder to the right/left.
Pull back sails gradually, rudder to the left.
Expand sails, keep them not shiver, rudder to the left.
Key notices regarding sailing in running water, swimming after stalled boats, and drying the boat.
A quick start guide for sail setup and operation checks.
Guide for diagnosing and solving common problems like connectivity and boat direction.
To Next Page