Operating and Safety
Instructions
Item No. OSI00002 Rev. 11/06
Induction Range
Model Description Voltage HZ Watts Plug
59500 Countertop – Single 120 60 1800 5-15P
Thank you for purchasing this Vollrath Mirage™ Induction range. Before operating this unit, read and familiarize yourself with
the following operating and safety instructions. SAVE THE ORIGINAL BOX AND PACKAGING. They should be used to ship
the unit if repairs are needed. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
WARNING
ELECTRIC SHOCK, FIRE OR BURN INJURIES CAN
OCCUR IF THIS EQUIPMENT IS NOT USED
PROPERLY. TO REDUCE RISK OF INJURY:
Plug only into grounded electrical outlets
matching the nameplate rated voltage.
Do not leave an empty pan on an operating unit.
Unit should only be used in a flat, level position.
Unplug unit and let it cool before cleaning or
moving.
Do not touch cooking surface. It remains hot
after the unit is turned off.
Do not spray controls or outside of unit with
liquids or cleaning agents.
Unplug when not in use.
Keep induction unit and power cord away from
open flames, electric burners or excessive heat.
Do not heat sealed cans or containers as they
may explode.
Handle hot cookware carefully.
Do not place any objects inside the air intake or
exhaust panels.
Do not operate unattended.
Closely supervise units operating in public areas
and/or around children.
Do not operate if unit has been damaged or is
malfunctioning in any way.
Do not place weight on the front control knob.
FUNCTION AND PURPOSE
This unit is intended to be used with induction ready
cookware (see below) with a flat, magnetic base measuring
4.5 inches (11.5 cm) through 14 inches (26 cm).
INDUCTION READY COOKWARE
Iron
Cast iron
Ferrous stainless steel
UNSUITABLE COOKWARE
Cookware with a diameter of less than 4.5”
Pottery, glass, aluminum, bronze or copper
cookware
Cookware with any type of footed base
INSTALLATION
This unit is to be used on a flat, level surface. The unit is not
designed to be enclosed or built into any area.
IMPORTANT: There must be a minimum of 4” (10 cm) of
space between the induction range and any surrounding
surface to allow sufficient airflow around the unit. Blocking
the airflow could overheat the unit.
ENGLISH
59500
To Next Page
General
