www.volta.com.tr
37
4.MAINTENANCE AND CONTROL
Fuse Exchange
The vehicle's charging circuit is protected by a 35A fuse against outside
intervention and the charger's breakdown. In case of malfunction, it must be
replaced. For this;
• Make sure the vehicle is in the o position.
• Unlock the seat of your vehicle.
• The fuse is located just under the seat.
• Separate the seat pool from the vehicle.
• Replace with a fuse of equivalent specification.
Rear Wheels and Suspensions
• Raise the vehicle to the rear stand. Push the rear wheel shaft back and
forth by hand. In case of the slightest gap, re-tighten. Make sure it is
fully tightened and in full position.
• Make sure that all the nuts holding the front and rear suspension are
tightened. If the suspension connections are not tight, it will cause
some connection points to be subjected to more force than usual. This
can cause damage and result in an accident.
Adjusting the Throttle Lever
• Check that the throttle lever can easily move to the bottom and top.
• The distance from the highest position to the first throttle response
should be between 2 and 6 mm. To adjust this, loosen the jam nut, turn
the adjuster and tighten it again.
WARNING
• Using a fuse below the specified capacity may cause the system to be permanently cut o,
and using it above the specified capacity may cause the electronic parts to break down and
the cables to be damaged due to high currents.
• Do not use high pressure water while washing your vehicle. It will damage your electrical
systems.
To Next Page
Loading...
Need help?
General
