www.volta.com.tr
10
3.ACTUATION AND USAGE
• Damaged chargers due to voltage dierences in your electrical installation may damage
your vehicle. These types of faults are not covered by the warranty.
• Plugging the charger into the socket first will protect your vehicle from possible high/low
voltage situations.
• Charging at least once a month will extend the life of your battery.
• When the battery is fully charged, disconnect it from the charger.
WARNING
Charger
Hand-delivered your electric motorcycle with the vehicle before its first ride
charge the charger for 6-8 hours. Please observe the following instructions to
charge the vehicle;
• Make sure your electric motor is switched o.
• First plug the part of the charger marked ‘‘2’’ into the wall socket.
• Then insert the part of the charger marked ‘‘1’’ into the charging port on
your vehicle.
• Arc/spark may occur when installing the charger on the vehicle.
• Two warning strips are located on the charger. The first LED is solid red,
indicating it is working, while the other LED turns red during charging and
green when the battery is full. If the charger has a red green color, the
battery is full. If your charger is a single LED, it turns red during charging
and green when charging is finished.
• Wait until the light on the indicator is green.
• After the charging has been completed, remove the plug from the charging
port and the charger from the wall socket. Disconnecting the charger from
the wall socket will extend the life of the product.
CAUTION
• If the battery charge time exceeds the time specified in the manual, please contact the
authorized services.
• During the winter, the performance of the battery and range of your vehicle may decrease
Use only the original charger specifically designed for your product.
• Your electric motor bike must be switched o when charging.
• Never shake your vehicle when charging.
1
2
To Next Page
Loading...
Need help?
General
