www.volta.com.tr
13
4.MAINTENANCE AND CONTROL
Change of Circuit Breaker
The vehicle's charging circuit is susceptible to external intervention
and charger breakdown,protected by a 63A fuse. Replacing it in case of
malfunction
must. For this;
• Make sure the vehicle is in the o position.
• Unlock the seat of your vehicle.
• The fuse is located just under the seat.
• Separate the seat pool from the vehicle.
• Replace with a fuse of equivalent specification.
Rear Rim and Suspensions
• Raise the vehicle to the rear stand. Push the rear wheel shaft back and
forth by hand. In case of the slightest gap, re-tighten. totally bored.
Make sure it is in the correct position.
• Make sure all the nuts holding the front and rear suspension are tight.
Please be. If the suspension connections are not tight, it will cause some
connection points to be subjected to more force than usual. This may
cause damage and resultant accident.
Adjusting the Throttle Lever
• Check that the throttle can easily move to the top and bottom.
Please pay.
• From the top position to the position where it gives the first throttle
response the distance should be between 2 and 6 mm. Tighten to set it
loosen the nut, turn the adjuster and tighten it again.
CAUTION
• The use of fuses below the specified capacity will cause the system to be permanently
cut o, If it is used above the capacity, it is possible to use the electronic parts due to high
currents.may cause malfunction and damage to the cables.
• Do not use high pressure water while washing your vehicle. It will damage your electrical
systems.
To Next Page
Loading...