VOLTCRAFT DLP-3303 - Utility Settings; Brightness; Beeper; Clock

18
To set the output mode:
(1) Press the Utility key. The Output mode menu is selected.
(2) Press the ▲ / ▼ key to select the output mode. Press the key to check and
enter the selected mode.
4.7 Utility Settings
4.7.1 Brightness
Press the Utility key, turn the knob to select [Utility]. Press the ▼ key to select
Brightness submenu. Press the ＜ / ＞ key to adjust the screen brightness. The
brightness can be set to 0%, 25%, 50%, 75%, 100%.
4.7.2 Beeper
Press the Utility key, turn the knob to select [Utility]. Press the ▼ key to select Beeper
submenu. Press the ＜ / ＞ key to turn on/off the beeper. When the beeper is on, the
icon will be lighted on the status bar. When the system prompts the instrument will
make a buzzing sound, e.g. cutting off the output due to O.V.P/O.C.P.
4.7.3 Clock
Press the Utility key, turn the knob to select [Utility]. Press the ▼ key to select Clock
submenu. Use the numeric keys to input, press the key to confirm. Press the ＜ /
＞ key to move the cursor.
4.8 System Info
4.8.1 View System Information
Press the Utility key, turn the knob to select [Info]. The Info sub menu is selected. You
can view the version, serial number, and checksum.
4.8.2 Set as Default
Press the Utility key, turn the knob to select [Info]. Press the ▼ key to select Default
submenu. Press the key to use the factory defaults, see table below.
Output
settings
Output
VOLT
CURR
CH1
12.000V 2.000A
CH2
CH3
3.300V
0.500A