29
AC Alternating quantity for voltage
DC Identical magnitude for current
V Volt (unit of electric potential)
Z Ohm (unit of electric resistance)
kΩ Kilo Ohm (exp.3)
MΩ Mega Ohm (exp.6)
nF Nanofarad (unit of electric capacity, exp.-9, symbol )
µF Microfarad (exp.-6)
mF Millifarad (exp.-3)
mH Milli-Henry (exp.-3)
H Henry (unit of electric inductivity)
MAX Maximum value display
MIN Minimum value display
Measuring operation
Do not exceed the maximum permitted input values. Do not contact circuits or
parts of circuits if there could be voltages higher than 25 V ACrms or 35 V DC
present within them. Mortal danger!
Before measuring, check the connected measuring lines for damage such as,
for example, cuts, cracks or squeezing. Defective measuring cables must no
longer be used.
During measuring, do not grip beyond the tangible grip range markings pre-
sent on the test prods.
Measuring is only permitted with closed housing and battery compartment.
You may only connect the two measuring leads to the measuring device that
are required for measuring operation. Remove all measuring leads not required
from the device for safety reasons.
☞
As soon as “OL” (overload) appears on the display, you have exceeded the measu-
ring range.
a) Turning the measuring device on
The measuring instrument is turned on again via the rotary switch (5). Turn the rotary switch to the
desired measuring function. Turn the rotary switch to “OFF” to turn the device off. Always turn the mea-
suring device off when it is not in use (position “OFF”).
To Next Page
Loading...
