41
µF Microfarad (exp-6)
mF Millifarad (exp-3)
ºC Degrees Celsius (unit of temperature)
ºF Degrees Fahrenheit
W Watt (unit of real power)
VA Volt-ampere (unit of apparent power)
cos φ Cosine phi (power factor)
% Percentage display for the measuring range from 4 mA to 20 mA or the duty cycle
MIN Display of the lowest recorded measurement
MAX Display of the highest recorded measurement
PEAK Display of the current peak value
HOLD Stands for “Data Hold”; the measured value is retained (e.g., for logging) until the EXIT
button has been pressed or the multimeter switched off.
LOW Indicates that value is below the set lower limit level
HIGH Indicates that value is above the set upper limit level
SET Setup functions can be set.
STO “Store”; the measured value is recorded by the data logger (data memory).
RCL “Recall”; readout of data from data memory
No. Display of memory location for measurement recording
SEND Data transmission to workstation computer is running
To Next Page
Loading...
Need help?
General
