VOLTECH AT3600 USER MANUAL PROGRAMMING TESTS
TEST PROGRAM EDITOR VPN 98 - 024 PAGE 3.4.13.
Choosing the test limits
The test limits can be:
% A nominal value together with + and – percentage limits.
>< Minimum and maximum values
> A minimum value only
< A maximum value only
Use the PC Editor’s ‘measure’ button (together with a sample part) if you are unsure
of the nominal value.
Typically, D is tested against a maximum value. A typical film dielectric capacitor
may have a D < 0.01. Because D is a ratio of two impedances it has no units.
To Next Page
Loading...