PROGRAMMING TESTS VOLTECH AT3600 USER MANUAL
PAGE 3.4.62. VPN 98 - 024 TEST PROGRAM EDITOR
3. Select the terminals to be included for both high and low terminals. For both high
and low terminals, select each terminal in turn and click on the ‘Add’ button at the
bottom of the list. Terminals can be removed from the used list by selecting them
and clicking on the ‘Remove’ button.
4. Select the current limit. There is only a maximum limit for this test. Note, you
may use the measure button to find the current which flows and set your limits
based on that, however in most cases the current limit will be determined by the
safety standard to which you are working.
5. Select ‘OK’. The test specification will then be displayed in the program window.
To Next Page
Loading...