OVERVIEW VOLTECH AT3600 USER MANUAL
PAGE 1.3.6 VPN 98-024 INTRODUCTION
STORING PROGRAMS AND RESULTS - THE SERVER
The Editor software previously described, allows you to create and evaluate each
individual test program. It is not intended to manage the large numbers of test
programs that may be required on a daily basis once they are in ‘production’ use.
This is the function of a second PC program supplied with your AT3600.
Usually, the Server would be installed on a PC with access to a large disk, which
could be attached to the PC itself, or connected via a network. The Server (and disk)
could then be optionally used for either or both of two purposes:
• To provide the master archive for test programs
• To archive test results
The tester has a separate 'Server' port on its rear panel for connecting to the Server.
TRANSFERRING PROGRAMS BETWEEN EDITOR AND SERVER
Within your establishment, there are several possible ways in which the Server and
Editor may be installed and used, depending on how many separate PC’s are
available.
The standard installation uses separate PC’s for the Editor and Server:
Transferring a new test program from the Editor to the Server archive can be done in
any of three ways:
• Via the tester
• Directly from PC to PC via a floppy disk
• Via a network connection between the PC’s using ‘Save As’ in the Editor to
transfer the program to the directory used by the Server for programs.
Auxiliary Port
Server Port
Programs
To Next Page
Loading...