TEST RESULTS HANDLING VOLTECH AT3600 USER MANUAL
When you have finished typing the code, return to the ‘Sheet 1’ of the spreadsheet.
To run the code, again from the Excel top-level menu bar, select:
Tools > Macro
At the dialog box, select the name of the macro ‘OLE_Demo’, and click on the RUN
button.
The code will now start to run, and after a few seconds, you will see the first message
box defined in the code:
Click on the OK button. When you have pressed the RUN soft-key and the first
result has been read, the message box will disappear, and you will then see the first
result entered into cell F3 of the spreadsheet.
Continue pressing the RUN soft-key until the second message box is seen.
Click on the OK button to finish running the code.
ADDITIONAL NOTES FOR THE ABOVE EXAMPLE
If there appear to be any problems while the code is running, press the escape key.
This will halt the execution, and bring up a dialog box to allow you to either exit
from the code execution, or to debug your code, for example by single-stepping
through it.
Once the results have been placed into cells in the spreadsheet, standard Excel
functions may be used to perform further analysis on the data, or to present the data
in different ways. As an example, you may wish to use the Excel Chart Wizard to
produce a graph of the results. Alternatively, you may wish to add further code to the
example shown above, as another way of extending the functionality. For guidance
of what may be possible, please refer to the Microsoft Excel user manuals.
PAGE 4.3.30. VPN 98 - 024 USING THE SERVER
To Next Page
Loading...