VOLTECH AT3600 USER MANUAL OVERVIEW
INTRODUCTION VPN 98 - 024 PAGE 1.3.9.
Advantages
• Requires only occasional use of a PC (which could be a portable) to develop
test programs and load them into the AT.
• Test programs can be executed by the AT without the PC attached, which
may be of advantage if the working space is limited.
Limitations
• Suitable for small numbers of test programs (e.g. <50).
• Test results cannot be archived to disk, or analyzed by other Windows based
applications.
TEST FIXTURES
When running the test program in production, how do you connect your transformer
with its own arrangement of terminals to the test nodes of the AT Series tester?
The AT Series has been designed with its own test fixture system to answer just this
question:
• Fixtures are constructed on a standard ‘fixture board’ which fits into the top
surface of the tester.
• The fixture system uses Kelvin connections to give the best possible
measurements when testing wound components.
• The fixture system will accommodate different types of connectors suitable
for both PCB mounting and flying lead transformers.
• A single test fixture can be used for all transformers wound on the same
bobbin.
To Next Page
Loading...