VOLTECH AT3600 USER MANUAL EXECUTE MODE
3.2. EXECUTE MODE WITH OPTIONS ENABLED
As stated in Chapter 3 ‘The test program editor’, programs may be created with the
following three options enabled or disabled:
Operator name
Batch numbers
Serial numbers
In each case, if the option is enabled, the data entered by the operator for that option
is included with the results which are sent back to the server. This additional data is
then available to be used as you wish; for example, it may be included your
production reports.
Note that these options are part of the program, not global settings for the AT,
allowing you to enable different options for each transformer as required.
When running programs where any of the above options are enabled, after the ‘Fit the
Fixture’ display, there will be additional displays (depending on which options are
enabled), before the RUN-FINISH display.
FRONT PANEL OPERATION VPN 98 - 024 PAGE 6.3.7.
To Next Page
Loading...