TRANSFORMER TESTS VOLTECH AT3600 USER MANUAL
PAGE 7.1.28. VPN 98 - 024 TESTS AND TEST CONDITIONS
• Select the integration time required.
• Enter the terminal names between which the X resistance is to be measured.
• Enter the terminal names between which the Y resistance is to be measured.
• Set the specific resistance for both X and Y terminals, and then set the negative
and positive percentage (%) limits.
• Select OK. The test specification will now be displayed in the program window.
Use the PC Editor’s ‘Measure’ button (together with a sample part) if you are unsure
of how to choose the test conditions.
CHOOSING TEST LIMITS
The test limits are the specific resistances for both X and Y terminals together with +
and – percentage limits.
Use the PC Editor’s ‘Measure’ button (together with a sample part) if you are unsure
of the resistance values.
To Next Page
Loading...