INTERFACE DETAILS VOLTECH AT3600 USER MANUAL
The HP ‘Smart Wand’ reader connects directly to the AT3600’s barcode port; no
extra interfacing is required to configure the HBSW-8300. Plug the barcode
reader into the port and switch the AT3600 on. The barcode reader is configured
by simply scanning the three barcodes printed below:
19 200 Baud
0’s Parity (none)
1 Stop bit
2.2. SERVER PORT
RS232 interface for connection to a PC server running the Voltech server software.
25-pin male D-type connector.
Pin Signal name Pin Signal name
1 Ground (Earth) 6 No connection
2 i/p RX 7 0V
3 o/p TX 8 No connection
4 i/p CTS ...
5 o/p RTS 25 No connection
PAGE 8.2.2. VPN 98 - 024 INTERFACE DETAILS
To Next Page
Loading...