VOLTECH AT3600 USER MANUAL QUICK START TUTORIAL
GETTING STARTED VPN 98 - 024 PAGE 2.3.15.
Before running any new test program, return the tester to the top-level menu by
pressing the FINISH soft-key (i.e. the 2nd soft-key from the top).
Use the following sequence of key-presses to ensure that the AT is configured to use
the Server as the source for test programs:
• Press the soft-key PROGRAM to change to the following display:
• Press the soft-key SET-UP, and at the following display:
• Press the ↓ soft-key until the third line shows the words ‘Program Store’:
• If, as shown above, the origin is INTERNAL, then press the soft-key SERVER, so
the third line reads as follows:
• Press the soft-key EXIT to return to the ‘Program Mode’ display shown above.
To Next Page
Loading...