CREATING THE PROGRAM VOLTECH AT3600 USER MANUAL
PAGE 3.3.2. VPN 98 - 024 TEST PROGRAM EDITOR
3.1. SETTING THE PROGRAM OPTIONS
3.1.1. OVERVIEW
After you have created the program schematic, before starting to insert any tests in
the program, you should set up which program options you would like to use.
From the Top Level menu bar, select:
Program >
Options
You will then see the
following dialogue box:
You may now set up any of the following options by simply clicking with the left
button of the mouse:
*Results Printing
Printed reports may be obtained from the printer port of the tester as follows:
Off There will be no results printed out during
the test execution.
Failures Only The results of the tests producing a ‘fail’
result will be printed.
Full Reporting The results for all the tests in the program
will be printed out for each transformer
tested.
To Next Page
Loading...