CREATING THE PROGRAM VOLTECH AT3600 USER MANUAL
PAGE 3.3.26. VPN 98 - 024 TEST PROGRAM EDITOR
When it is finished, you will see a dialogue box containing the results of the test.
From the results, you should be able to see any tests where there may be problems.
Return to the Program Editor to make the necessary changes, then download the
program again, and run the corrected version.
Continue in this way until you are satisfied that the program is correct, before
archiving it for use in production.
The code at the end of each result line should normally be zero; any other code
signifies that an error occurred in the measurement.
At this point, you may want to protect your test program by setting an AT password.
To do this, select:
Tester > Set Password
The resulting dialogue (see below) allows
the AT password to be set. If a password is
set, this password will need to be entered
into the AT whenever a test program is
changed or deleted.
Note that this Editor dialogue also
allows the password to be reset. The
old password is not required to do this.
All that is required is for the new
password to be entered and verified.
To Next Page
Loading...