EasyManua.ls Logo

Volvo Penta VolvoPenta IPS Autopilot System DPU User Manual

Volvo Penta VolvoPenta IPS Autopilot System DPU
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Volvo Penta IPS
Autopilot
System
DPU Installation
and System
Connections
Document Number : 8705 43
Date: July 2006
87054_3.book Page 1 Tuesday, July 18, 2006 8:49 AM
Question and Answer IconNeed help?

Do you have a question about the Volvo Penta VolvoPenta IPS Autopilot System DPU and is the answer not in the manual?

Volvo Penta VolvoPenta IPS Autopilot System DPU Specifications

General IconGeneral
BrandVolvo Penta
ModelVolvoPenta IPS Autopilot System DPU
CategoryAutopilot System
LanguageEnglish

Summary

Handbook Information

Installation Procedures

1.1 Introduction

Describes the Volvo Penta IPS Autopilot System components and compatibility.

1.2 Parts Supplied

Lists the components included in the DPU parts kit and additional required parts.

1.3 Planning the installation

Provides essential safety information and precautions before starting the installation process.

1.4 S3G Course Computer

Refers to separate instructions for S3G Course Computer and fluxgate compass installation.

1.5 Control Head

Refers to separate instructions for Control Head installation.

1.6 Data Processing Unit (DPU)

Introduces the DPU and provides its physical dimensions.

Fitting the Data Processing Unit

Step-by-step guide for physically mounting the Data Processing Unit to a vertical surface.

1.7 Running SeaTalk & NMEA2000 cables

Provides guidelines for cable routing practices and identifying cable types.

1.8 System power

Details system power requirements and important cautions for the DPU.

1.9 Cable preparation

Explains how to prepare cables for the DPU's spring retention connectors.

1.10 Connections to DPU

Illustrates the required connections to and from the DPU, including ferrites.

1.11 Additional connections

Details further connections needed for the 5-way connector block and grounding.

1.12 Connecting to the Volvo Penta system

Guide to connecting the system to the Volvo Penta Gateway and interface unit.

1.13 EMC Conformance

Check installation for interference from radio transmissions and engine starting.

1.14 Post-installation Checks

Procedures to verify the installation before proceeding to the commissioning stage.