To Next PageTo Next Page
Need help?Do you have a question about the Volvo 2004 XC90 and is the answer not in the manual?
General| Brand | Volvo |
|---|---|
| Model | 2004 XC90 |
| Category | Automobile |
| Language | English |
Safety warnings for vehicles equipped with airbags.
Procedure to identify if the car is equipped with SRS.
Precautions for SRS wiring and steering system components.
Information on SRS warning lamp and sensor module location.
Steps to remove centre console side panels.
Adjusting seat positions and disconnecting the battery.
Procedure for removing the loudspeaker grille and speaker assembly.
Steps to remove instrument panel and its surround.
Accessing the dashboard panel using the gear selector lever.
Removing the bracket for the dashboard environment panel.
Installing the bracket for the carphone holder.
Marking and drilling holes for carphone holder installation.
Routing the wiring for the carphone holder.
Cutting grooves in the instrument panel surround for wiring.
Connecting wiring and reassembling dashboard panels.
Securing bracing and mounting plates for the carphone holder.
Attaching the carphone holder to the mounting plate.
Installing the mounting plate onto the bracket.
Connecting the main cable harnesses.
Mounting the handsfree box for Ericsson and Nokia models.
Installing bracket and connecting power supply.
Connecting the handsfree box to the car's pre-routed connector.
Removing the driver's seat head restraint.
Modifying head restraint upholstery for microphone installation.
Securing the head restraint upholstery zip fastener.
Routing the microphone cable through the seat.
Routing the head restraint cable to the centre console.
Routing cables to the Accessory Electronic Module (AEM).
Routing cables through seat and panel covers.
Routing cables via seat mountings and sill trim panels.
Routing cables through floor hatches and cargo area.
Routing cables under carpet and through door openings.
Connecting to and disconnecting the Accessory Electronic Module (AEM).
Connecting AEM wiring and reinstalling components.
Removing dashboard and door panels for aerial installation.
Removing A-post and sun visor mountings.
Removing interior lighting and rear view mirror.
Installing the aerial and routing its cable.
Securing the aerial cable to the existing harness.
Routing the aerial cable to the console and connecting.
Reinstalling various panels and system components.
Final steps: ignition, battery reconnection, and software programming.
