Check all cooling system hoses and connections for defects or deterioration of hoses and loose clamps or
fittings.
Drive belts
The belt tension can be checked by depressing the fan belt at a point midway between the alternator and
fan pulleys as illustrated. It should be possible to press down the belt about 1/4" - 3/8" (5-10 mm). This
also applies to other drive belts on the engine.
If drive belts are replaced, recheck belt tension after driving 600 - 1,200 miles (1,000 - 2,000 km).
Contents | Top of Page
w
To Next Page
Loading...
